https://www.youtube.com/watch?v=pysUCYz4wlM
He hasn't met a Mustang he doesn't like? I guess Ford people are pretty obvious about their bias.
Anyway, here's a 7.3 going into a Foxbody.
Right in the video they address people putting LS engines in Mustangs.
I do think this engine is going to be pretty popular with the Ford crowd. It won't be cheaper than going LS based for quite some time though. Or probably ever. But they're going to make a lot of these with the 10 speed autos (3/4 ton trucks and heavier, maybe into the F450/550). That would probably make a good swap (if it fits) into a Panther.
I don't dig the flaccid penis long throttle body. That just looks odd. Easy part to swap once the aftermarket starts covering this platform.
Ford 7.3L gas
Re: Ford 7.3L gas
https://www.youtube.com/watch?v=ML4SlsScnBY
Tear down, dyno results, comparison to Coyote and 351W.
Need to see a side by side compared to GM's new 6.6L though...the 7.3L is probably bigger.
So apparently Ford fanboys are really annoying....
Tear down, dyno results, comparison to Coyote and 351W.
Need to see a side by side compared to GM's new 6.6L though...the 7.3L is probably bigger.
So apparently Ford fanboys are really annoying....
There's a good response though.Ford guys are in a league of their own. I didn't see anyone tearing into Chevy's new 6.6 as soon as it left the showroom. (Maybe I missed it, don't pay much attention to Chevy)
lol. It's true.@Fordfanone That's because it's not a big deal when Chevy comes out with a new engine that's a good one. This is a new thing for Ford, especially since it's a pushrod motor.
Re: Ford 7.3L gas
Since Sloppy Mechanics has been leaning heavily on the new Holly computer stuff, it occurs to me that there is no reason he might end up playing with one of these at some point. Not sure when they'll fall to his budget though. I think it'll be a few years yet.
Re: Ford 7.3L gas
Part 3, bottom end.
https://www.youtube.com/watch?v=nlK-NW2pILM
That saw cut between the cylinders is....weird. Looks pretty thin.
https://www.youtube.com/watch?v=nlK-NW2pILM
That saw cut between the cylinders is....weird. Looks pretty thin.