Made a long voyage to Lakeville in the Ranger and the power steering started to die when I was 5 minutes from home (or I noticed it then).
I think this was predicable.
It's the return hose. Finally rusted through. Ordered a GATES 358320 from RockAuto which was a whole $15.27, shipped.
Shouldn't be too bad. Just need to figure out what P/S fluid this takes.
Ranger power steering
Ranger power steering
You do not have the required permissions to view the files attached to this post.
Re: Ranger power steering
It takes Type F (FA) ATF fluid.
New line is installed. Not too bad. Power steering is working normally. I soaked in PB first. Next I disconnected the rubber line at the reservoir. Then I pulled back the steering shaft plastic protective cover to reveal the fitting. It took a 5/8" flare nut wrench. Naturally it did fight me. Specifically I mean that the nut was rusted to the line so they were moving together until I finally worked it free. Then it wasn't too bad.
Only took like 1/2 qt of fluid.
New line is installed. Not too bad. Power steering is working normally. I soaked in PB first. Next I disconnected the rubber line at the reservoir. Then I pulled back the steering shaft plastic protective cover to reveal the fitting. It took a 5/8" flare nut wrench. Naturally it did fight me. Specifically I mean that the nut was rusted to the line so they were moving together until I finally worked it free. Then it wasn't too bad.
Only took like 1/2 qt of fluid.
You do not have the required permissions to view the files attached to this post.